I installed a software that let me use the PC as an oscilloscope , but
it does not mention how to connect the circuits to be tested with the computer an through which port.Does anyone lead me?
I mean how can I connect that cable to
the circuit ?

A D V E R T I S E M E N T

The entry 'How can I connect the electronic circuit to the computer when I to use it as an oscilloscope?' was posted under category: Measurement. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Related post:

2 Responses to “How can I connect the electronic circuit to the computer when I to use it as an oscilloscope?”

  1. menotu3169 writes:
    No. 1 — February 10th, 2010 at 2:34 am

    Programs like that typically use the sound card as an A to D converter.
    You probably have to use the input port on your sound card(either mic in or aux in). You may be able to buy a cable from your local electronics shop or you may have to make your own.

    About the only way to connect this cable to your circuit would be to use alligator clips.

  2. noname writes:
    No. 2 — February 10th, 2010 at 2:59 am

    I depend on the circuit and how it will communicate to the computer. I am sure you will need some kind of buffer circuit and some kind of communication protocol, serial USART, Parallel or USB etc. Be careful, you might burn up some port or something else if you don’t know what are you doing.

Leave a Reply

Tags: circuit,  computer,  connect,  electronic,  oscilloscope, 

Incoming search terms:

pc oscilloscope circuit diagram, schematic oscilloscope pc, curcut digram smol ocslescop by compuater, the block diagram of sound card, sound card oscilloscope circuit diagram
«
»

Powered by Yahoo! Answers